Category:
Practical questions
Regardless of the model, your pool cover can always be opened or closed manually. Even in the event of a battery failure, there is always a solution! However, the manual manoeuvre should only be used in the event of a power failure and should not be used to loosen your cover.
1. Remove the 2 flaps (one on each side of the trim). For modules without cylinders, go directly to point 3.
2. Lift the trim on each side until you hear the click.
3. Identify the red motor cable and disconnect it.
4. Identify the manual manoeuvring flange and insert the extension provided during installation.
5. Place the racagnac (ratchet wrench) at the end of the extension, and adjust the knob to the desired position.
You can now operate the system to open or close the cover. To put your cover back in place, reverse the steps from 5 to 1. To lower the trim (only on models equipped with cylinders), actuate the two levers inside it by lifting it slightly before lowering it again.